ORIFICE FOR FOAMJET 1.1MM 10.5000 S using 'Bite the Wire'

S using 'Bite the Wire' technology when installing the rigid and swivel fittings

1x 3/8" Stainless Steel Plug Inlet (pre-installed)

The internal agitator then creates the dense foam which maximizes dwell time on the surface that needs to be cleaned

Since a pump only uses a small amount of water per minute compared to the volume that a standard city line can produce

ORIFICE FOR FOAMJET 1.1MM 10.5000 S using 'Bite the Wire'Description MTM Hydro Foam Cannon orifices are meant to allow foam cannons to be used on a variety of machines with varying PSI and GPM. These orifices (aka nozzles) will more accurately accommodate a machine requiring a larger or smaller orifice which is estimated in the ranges of flow exceeding 4 gallons per minute or below 2 gallons per minute. The purpose is not to increase or decrease pressure but rather to match as closely as possible, to the