Takaab MIX-X - Three Channel Expander for Takaab MIX v2 & Takaab 2MIX & 2MIX-1U Expander The SQS can switch at

The SQS can switch at audio rate so you can also use a VCO as a trigger source

If the signal at IN1 is high (above 1V) then OUT1 will output 0V

The signal of gate 1 can be normalized to the input of gate 2

In this use case note that the +ve and -ve labels are reversed so the +ve IN will send the negative part of the signal to be summed and vice versa

Takaab MIX-X - Three Channel Expander for Takaab MIX v2 & Takaab 2MIX & 2MIX-1U Expander The SQS can switch at* This is a not a standalone module. For use only with Takaab MIX v2, Takaab 2MIX or 2MIX 1U * Adds three extra channels to the Takaab MIX. or Takaab 2MIX. Connections Use a 2. 54mm 2 pin jumper cable to connect to one of the three pin pairs on the MIX. Make sure to connect GND to GND (top row of pins) and SIG to SIG (bottom row); the cable should not twist. You can connect up to three MIX Xs to one MIX this way. Package Contents 1x Module, 1x 2 pin