Takaab SMULTI-1U Switched Passive Multiple Passive To do this use a

To do this use a jumper to connect AIN* to BNORM

The TUNE control allows for trimming of the pitch by half an octave up and down while PULSE WIDTH sweeps the duty cycle of the square wave from 50% to just under 100% positive

There are also headers on the boards that allow for normalizing the RESET and CLOCK IN jacks of the adjacent clock dividers

Our passive diode rectifier now in 1U

Takaab SMULTI-1U Switched Passive Multiple Passive To do this use aThis passive module works as a 1 in 6 out multiple or as two smaller multiples. Any signal or voltage put into the top input will be split between the 6 outputs of the module. When a signal or voltage is added into the lower input, this creates two separate multiples So the top input is then split between the top three outputs, and the lower input is split between the bottom 3 outputs. As this is a passive module, expect some drop in level. However,