Diamond Block For Smoothing Printed Model Supports Apply gentle pressure and rub

Apply gentle pressure and rub the model back and forth on the block for 2 to 3 repetitions

Say goodbye to the frustration of dealing with a dried-out sponge

When opened

evaporated water jars with unsightly rings

Diamond Block For Smoothing Printed Model Supports Apply gentle pressure and rubTo achieve a smooth finish and precise fit for your printed model, utilize the Diamond Block featuring a non slip base. Once the model is cured and separated from its supports, place it on the block in a flat position. Apply gentle pressure and rub the model back and forth on the block for 2 to 3 repetitions. This process removes support nubs and ensures a flat bottom and accurate alignment with the Diamond Articulator base.