Flashforge PETG 1kg 1.75mm - Fits the Creator Pro, Guider 2/2S & Creator 3 Colour:Green The lower the temperature the

The lower the temperature the higher quality the print

Post processing PolyMax PC is easy

Mavic Propeller Guard

but not as much

Flashforge PETG 1kg 1.75mm - Fits the Creator Pro, Guider 2/2S & Creator 3 Colour:Green The lower the temperature theFlashforge PETG is great quality and a very reliable filament with extra toughness over PLA. It prints at the same temps as Flashforge ABS with a temperature window of 220 240 degrees C. The recommended bed temp is 80 degrees C. You may need to decrease your extrusion ratio a little if you experience any burnt lumps building up on your nozzle and dropping off on your prints PETG in general is sensitive to over extrusion. The 1kg spools fit the Creator