Pay in 4 interest-free payments of $13.50 Learn more
Ships within 48 hours · Estimated delivery Aug 11 - Aug 16
Requirements
Over time you may want to clean the interchangeable tips
Push the replacement tip in fully and tighten the locking nut
We had good results when heat treating in an oven at 110C (225F) for an hour
BuildTak - 406 mm x 406 mm (16.0" x 16.0") screw RequirementsIdeal build surface for FFF 3D printers. Key Features: Works with ABS, PLA, HIPS, PET+, Brick, Wood & Flexible (TPE) filaments; additionally we have had success with getting nylon and t glase (PETT) to adhere when used with a thin layer of washable glue stick on the BuildTak surface Installs much easier than masking tape or films typically used and with fewer chances of air bubbles Protects build plate Heat resistant and durable, can be reused for
